text.skipToContent text.skipToNavigation

Ancoragem perno 24/60


Functioning - The FAZ II is suitable for pre-positioned and push-through installation also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.

Descrição completa 
Referência 503184FIS
Diâmetro
Comprimento
Marca Fischer
Características principais Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Peso por peça (g) 864.2
Veja todas as especificações 
Embalado por 1

Especificações

Diâmetro M24
Comprimento 88 mm
Marca Fischer
Características principais Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Peso por peça (g) 864.2
Info
  • do= Nominal diameter of drill bit.
  • Min. td= Recommended drilling depth.
  • hef= Effective anchorage depth.
  • tfix= Grip range.
  • s = Width across flats.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Descrição

Functioning - The FAZ II is suitable for pre-positioned and push-through installation also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.

Números do artigo

Referência 503184FIS
EAN 4048962055122
UBB 500616662564
UNSPSC 31162101
Artigo do fabricante nr 503184
Não feche esta página. Esta mensagem desaparecerá, quando a página estiver totalmente carregada.