text.skipToContent text.skipToNavigation

Ancoragem perno 24/30


Referência 501427FIS
Diâmetro
Comprimento
Marca Fischer
Características principais Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info
  • do= Nominal diameter of drill bit.
  • Min. td= Recommended drilling depth.
  • hef= Effective anchorage depth.
  • tfix= Grip range.
  • s = Width across flats.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.
Veja todas as especificações 
Embalado por 1

Especificações

Diâmetro M24
Comprimento 58 mm
Marca Fischer
Características principais Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info
  • do= Nominal diameter of drill bit.
  • Min. td= Recommended drilling depth.
  • hef= Effective anchorage depth.
  • tfix= Grip range.
  • s = Width across flats.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Números do artigo

Referência 501427FIS
EAN 4048962006599
UBB 500616660584
UNSPSC 31162101
Artigo do fabricante nr 501427
Não feche esta página. Esta mensagem desaparecerá, quando a página estiver totalmente carregada.