text.skipToContent text.skipToNavigation

Goujon d'ancrage 24/30

Numéro d'article 501427FIS
Diamètre
Longueur
Marque Fischer
Principales caractéristiques Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info
  • do= Nominal diameter of drill bit.
  • Min. td= Recommended drilling depth.
  • hef= Effective anchorage depth.
  • tfix= Grip range.
  • s = Width across flats.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.
Voir toutes les spécifications 

Spécifications

Diamètre M24
Longueur 58 mm
Marque Fischer
Principales caractéristiques Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info
  • do= Nominal diameter of drill bit.
  • Min. td= Recommended drilling depth.
  • hef= Effective anchorage depth.
  • tfix= Grip range.
  • s = Width across flats.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Numéros d'articles

Numéro d'article 501427FIS
EAN 4048962006599
UBB 500616660584
UNSPSC 31162101
N° Article du fabricant 501427
Ne fermez pas cette page. Ce message disparaîtra lorsque la page sera entièrement téléchargée.