Anclaje perno 24/30

Artículo No.	501427FIS
Diámetro
Longitud
Marca	Fischer
Características clave	Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info	d_o= Nominal diameter of drill bit. Min. t_d= Recommended drilling depth. h_ef= Effective anchorage depth. t_fix= Grip range. s = Width across flats. kN = Load in kN. The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γ_f= 1,4 and if the S_cr, N and C_cr, N are taken in to account. Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Ver todas las especificaciones

Embalado por 1

Especificaciones

Diámetro	M24
Longitud	58 mm
Marca	Fischer
Características clave	Functioning - The FAZ II is suitable for pre-positioned and push-through installation and is also ideal for stand-off installation thanks to the long thread. - When applying the torque, the cone bolt is pulled into the expansion sleeve and expand it against the drill hole wall. - The anchor is set in line with the approval once the preset installation torque is achieved. - In the case of series installation, we recommend using the FABS anchor bolt setting tool.
Info	d_o= Nominal diameter of drill bit. Min. t_d= Recommended drilling depth. h_ef= Effective anchorage depth. t_fix= Grip range. s = Width across flats. kN = Load in kN. The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γ_f= 1,4 and if the S_cr, N and C_cr, N are taken in to account. Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Descargar como PDF Imprimir

Descargar como PDF Imprimir