text.skipToContent text.skipToNavigation

Through bolt anchor Steel Zinc plated

Article number
Material Steel
Approval ETA Option 1
Surface treatment Zinc plated
Thread Metric thread
Info
  • Code = Letter code marking
  • do = Nominal diameter of drill bit
  • df = Diameter of clearance hole in the fixture
  • h1 = Depth of drilled hole to deepest point
  • hnom = Minimum hole depth
  • hef = Effective anchorage depth
  • tfix(max) = Grip range
  • s = Width across flats
  • ring ø = Washer diameter
  • Scr,N = Spacing characteristic
  • Ccr,N = Edge distance characteristic
  • Smin. = Minimal spacing
  • Cmin. = Minimal edge distance
  • Nrec = Recommended load in kN
  • Tinst = Tightening torque in Nm
  • The allowable load (Nrec) is valid for one single anchor, at non-cracked concrete (pressure zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr,N and Ccr,N are taken in to account.
  • When reduction on spacing and edge distance take place a re-calculation of forces should be carried out by making use of the technical guide, they are available on request.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Specifications

Material Steel
Approval ETA Option 1
Surface treatment Zinc plated
Thread Metric thread
Info
  • Code = Letter code marking
  • do = Nominal diameter of drill bit
  • df = Diameter of clearance hole in the fixture
  • h1 = Depth of drilled hole to deepest point
  • hnom = Minimum hole depth
  • hef = Effective anchorage depth
  • tfix(max) = Grip range
  • s = Width across flats
  • ring ø = Washer diameter
  • Scr,N = Spacing characteristic
  • Ccr,N = Edge distance characteristic
  • Smin. = Minimal spacing
  • Cmin. = Minimal edge distance
  • Nrec = Recommended load in kN
  • Tinst = Tightening torque in Nm
  • The allowable load (Nrec) is valid for one single anchor, at non-cracked concrete (pressure zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr,N and Ccr,N are taken in to account.
  • When reduction on spacing and edge distance take place a re-calculation of forces should be carried out by making use of the technical guide, they are available on request.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

You have searched for "maxxfast". We have found variants.

  Stock Net price   Sign up
Do not close this page. This message will disappear, when the page is fully loaded.